
Chapter 1 Introduction
No. | Name of Parts | Outline of Functions |
|
|
|
1 | Top Cover Assy | Stores the printed output. If required the additional |
|
| 2 paper supports can be also used to support the |
|
| paper. The plate at the top can be raised and |
|
| secured.The paper stopper on the front can be |
|
| pulled out, the upright support raised and then |
|
| adjusted back to the required paper size. |
|
|
|
2 | Operator Panel | To configure and advise the status of the printer. |
|
|
|
3 | Front Cover | To gain access to the toner cartridges and waste |
|
| toner pack. |
|
|
|
4 | Rear Cover Assy | Transfers images onto the page and transports the |
|
| paper. May be required to be opened when clearing |
|
| internal jam or trouble shooting and when replac- |
|
| ing the fuser unit |
|
|
|
5 | Top cover | Allows access to the OPC Belt Cartridge and trans- |
|
| fer belt cleaner. |
|
|
|
6 | Power Switch | To power on or off the printer. |
|
|
|
7 | AC Input Inlet | To connect a power supply cable. |
|
|
|
8 | Interface Control Box | Controller board with USB and Ethernet connec- |
|
| tors. |
|
|
|
9/ | Upper/Lower Duplex | To be removed only when installing the duplex |
10 | Cover | unit. |
|
|
|