HP 8008N manual Job Library Errors

Chapter 4 Control Panel Functions

Submenu	Default Setting	Available Settings	Procedure for Changing Setting
	Delete		1.	Press NEXT or PREVIOUS to scroll
	Job1			through the Print Job Names.
			2.	Press SELECT to choose the
				desired Print Job to Delete.
	Job Name	This step is necessary if	1. Press NEXT or PREVIOUS to
	PIN	the job is a PRIVATE job.		increase or decrease each digit of
				the four-digit number.
			2.	Press SELECT to set one digit and
				move to the next digit.
			3.	Press SELECT after changing the
				last digit to save this setting.

4.6.1 Job Library Errors

When a Job Library error occurs, the following message will be displayed:

JOBLIB Error XX Press Start

This is a continuable-fault, which means the START key must be pressed to allow operations to continue. If the current job is aborted as a result of the error, the message"Canceling Job" may be displayed after START is pressed. "XX" in the error display above is an error code. The error codes for this message are:

z01 – Data stream was missing a Job Name specification. (Job will be aborted.)

z02 – Data stream was missing a User Name specification. (Job will be aborted.)

z03 – Data stream was missing a PIN specification. (Job will be aborted.)

z04 – Attempted to overwrite a PRIVATE job, but PIN did not match. (Job will be aborted.)

z05 – Insufficient storage. (Job will be aborted only if it is a PRIVATE job.)

4-9