Omron FQM1-CM001 Operation Settings at Startup and Maintenance Functions, Program Protection

Operation Settings at Startup and Maintenance Functions Section 5-7

5-7 Operation Settings at Startup and Maintenance Functions

This section describes the following operation settings at startup and mainte- nance functions.

•Operating mode at startup

•Program protection

•Remote programming and monitoring

•Flash memory

5-7-1 Specifying the Startup Mode

The operating mode when the power is turned ON can be specified in the

System Setup.

Power ON

System Setup

Tab page	Name	Details	Settings	Default
Startup	Startup	Specifies the	System Setup disabled	System Setup
	Mode	initial operating	• RUN mode	disabled
		mode when the
			System Setup enabled
		power is turned
			• PROGRAM mode
		ON.
			• MONITOR mode
			• RUN mode

Note The operating mode at startup for Motion Control Modules will be the same as that for the Coordinator Module when in Sync Mode, but will be RUN mode when in ASync Mode.

5-7-2 Program Protection

The FQM1 provides the following kinds of protection for user programs.

Read Protection Using Passwords

Read and display access to the user program area can be blocked from the CX-Programmer. Protecting the program will prevent unauthorized copying of the program and loss of intellectual property.

A password is set for program protection from the CX-Programmer and read access is prevented to the whole program.

Note (1) If you forget the password, the program in the FQM1 cannot be trans- ferred to the computer.

(2)If you forget the password, programs can be transferred from the comput- er to the FQM1. Programs can be transferred from the computer to the FQM1 even if the password protection has not been released.

118