Omron FQM1-CM001 Wiring Servo Relay Units, Section, External Dimensions, Wiring Method

	Wiring Servo Relay Units				Section 3-4
External Dimensions
				Terminating resistance switch
			160
		Signal switches			4.5 dia.
					Phase B switches

100 90

41.7

30.7

15.9

Wiring Screw-less

Clamp Terminal

Blocks

Wiring Method

Screw-less clamp terminal blocks use clamps to attach wires, and do not require screws. In addition to control signal wiring to Servo Drivers, clamp ter- minal blocks can be used to connect sensors and external devices. A ferrule, however, must be connected to the sensor or external device cable when con- necting to clamp terminal blocks.

The following table shows the suitable ferrules.

Manufacturer	Model	Applicable wire
Phoenix Contact Inc.	AI-0.5-10	0.5 mm2 (20AWG)
	AI-0.75-10	0.75 mm2 (18AWG)
	AI-1.5-10	1.25 mm2 (16AWG)
Nihon Weidmuller Co. Ltd.	H 0.5/16 D	0.5 mm2 (20AWG)
	H 0.75/16 D	0.75 mm2 (18AWG)
	H 1.5/16 D	1.25 mm2 (16AWG)

•Inserting Wires

Insert the ferrule into the terminal hole.

•Removing Wires

Push and hold the release button on top of the terminal hole with a small flat-blade screwdriver and remove the wire.

																	Small minus screwdriver
NC							V	+											2	0
					V	+											3	0
															4	0
			V	+
													5	0
											6	0								1
		V	+
																				2
V	+									7	0
																				3
									8	0
																				4

Release button

The following screwdriver can be used when removing wires.

79