Omron FQM1-MMA21, FQM1-CM001, FQM1-MMP21 operation manual CX-Programmer, Section

CX-Programmer Section 1-4

1-4 CX-Programmer

The CX-Programmer provides software functions for programming and debugging.

FQM1 Patch Software must be installed for the CX-Programmer Ver. 5.0 (Model: WS02-CXPC1-E-V50) to use it to create ladder programs, make set- tings in the System Setup, and monitor operation. The FQM1 Patch Software can be installed for CX-Programmer Ver. 5.0 or later, but not to Ver. 4.0 or ear- lier versions. Refer to 8-1CX-Programmer.

CX-Programmer

Item		Details
Applicable Motion	FQM1 Series
Controllers	Note CX-Programmer can also be used for SYSMAC CS/CJ-
	series PLCs.
OS	Microsoft Windows	Microsoft Windows	Microsoft Windows
	95, 98, or NT4.0	2000 or Me	XP
	Service Pack 6
Personal computers	IBM PC/AT or com-	IBM PC/AT or com-	IBM PC/AT or com-
	patible	patible	patible
Connection method	Peripheral port or built-in RS-232C port on the Coordinator
	Module
Communications	Peripheral Bus or Host Link
protocol with FQM1
Offline functions	Programming, editing of I/O memory, System Setup, printing
Online functions	Transferring comparing data, monitoring, System Setup
Main functions	1. Programming functions: Creating and editing of applicable
	FQM1 ladder or mnemonic programs.
	2. Changing operating modes for each Module.
	3. Transfer functions: Transferring programs, I/O memory data,
	and System Setup between computer and Modules.
	4. Monitoring program execution status: Monitoring I/O bit sta-
	tus and PV using ladder display, monitoring I/O bit status
	and PV using mnemonic display, and monitoring PV using
	I/O memory display.

Note The CX-Programmer can be connected online to FQM1 Coordinator Modules and Motion Control Modules at the same time. If the default baud rate is changed when Coordinator and Motion Control Modules are connected at the same time, set the baud rate to 38.4 kpps max.

8