Omron FQM1-MMP21 Make System Setup settings, and monitor or debug operation, CS1W-CIF31

CX-ProgrammerSection 8-1

8-1	CX-Programmer
		Connect the CX-Programmer Support Software to the Coordinator Module to
		create and monitor programs for all Modules. While monitoring the ladder pro-
		grams in Motion Control Modules, it is possible to input operation conditions
		for monitoring the I/O of the Coordinator Module, and to debug programs.
		The FQM1 Patch Software is required to create the FQM1 ladder program,
		make System Setup settings, and monitor or debug operation.
		The FQM1 Patch Software must be installed for the CX-Programmer Ver. 5.0
		(Model: WS02-CXPC1-E-V50). It cannot be installed for the CX-Programmer
		Ver. 4.0 or earlier. To connect the FQM1 and a personal computer, use the
		cables shown in the following table.
	Name	Model	Specifications
Programming Device		CS1W-CN118	Connects a personal computer (Microsoft Windows OS).
Connecting Cables			D-Sub 9-pin receptacle (converts between RS-232C and peripheral com-
(for peripheral port)
			munications)
			(Length: 0.1 m)
		CS1W-CN226	Connects a personal computer (Microsoft Windows OS).
			D-Sub 9-pin (Length: 2.0 m)
		CS1W-CN626	Connects a personal computer (Microsoft Windows OS).
			D-Sub 9-pin (Length: 6.0 m)
Programming Device		XW2Z-200S-CV	Connects a personal computer (Microsoft Windows OS).
Connecting Cables			D-Sub 9-pin (Length: 2.0 m), Static-resistant connector used.
(for RS-232C port)
		XW2Z-500S-CV	Connects a personal computer (Microsoft Windows OS).
			D-Sub 9-pin (Length: 5.0 m), Static-resistant connector used.
		XW2Z-200S-V	Connects a personal computer (Microsoft Windows OS).
			D-Sub 9-pin (Length: 2.0 m) (see note)
		XW2Z-500S-V	Connects a personal computer (Microsoft Windows OS).
			D-Sub 9-pin (Length: 5.0 m) (see note)
USB-Serial Conver-		CS1W-CIF31	USB to D-Sub 9-pin conversion cable
sion Cable			(Length: 0.5 m)

Note These RS-232C Connecting Cables cannot be used to connect to the CX- Programmer with Peripheral Bus communications. Connect to the CX-Pro- gramer with Host Link (SYSMAC WAY) communications.

!Caution Never connect a PLC Programming Console (such as the C200H-PRO27) to the Coordinator Module’s peripheral port. The FQM1 may malfunction if a PLC Programming Console is connected.

234