Omron FQM1-MMA21, FQM1-CM001, FQM1-MMP21 operation manual 221

Analog Input Functions						Section 7-9
Word	Bits	Function			Settings		Controlled
							by
A570	00	Adjustment	Adjustment	Analog Input	OFF: Adjustment disabled.		User
		Mode Com-	Enable		ON: Adjustment enabled.
	01			Reserved
		mand Bits			When this bit is turned from
	02			Analog Output 1
		(Effective only
					OFF to ON, the default value
	03			Analog Output 2
		when A575 is			(offset or gain value) corre-
		5A5A hex.)			sponding to the selected I/O
					signal range is transferred to
					Adjustment Value Monitor
					Area (A572 and A573).
	04 to 06		Reserved
	07		Adjustment Mode	OFF: Offset adjustment			User
			Specifier	ON: Gain adjustment
	08 to 11		Reserved
	12		Adjustment Value	While this bit is ON, the offset or gain value will be			Motion
			Increment	incremented by one resolution unit each 0.5 s.			Control
							Module
	13		Adjustment Value	While this bit is ON, the offset or gain value will be
			Decrement	decremented by one resolution unit each 0.5 s.
	14		Adjustment Value	OFF to ON: Clears the adjustment data to the fac-
			Clear	tory defaults.
	15		Adjustment Value	OFF to ON: Reads the present value in the
			Set	Adjustment Value Monitor Area (A572
				and A573) and saves this value to
				flash memory. This adjustment value
				will be used for the next normal mode
				operation.
A571	00	Adjustment	Adjustment Oper-	ON when an operational error has been made,			Motion
		Mode Status	ation Error	such as turning ON both the Analog Input and Ana-			Control
				log Output 2 Adjustment Enable Bits at the same			Module
				time.
	01 to 14		Reserved
	15		Adjustment Mode	ON during adjustment mode operation (when A575
			Started	contains 5A5A hex).
A572	00 to 15	Adjustment	Used for Analog	Setting Offset Moni-	The values in	• −10 to 10 V:	Motion
		Mode Monitor	Input and Analog	tor	these words	FE0C to	Control
		(Effective only	Outputs 1/2		can be over-	01F4 hex	Module or
					written	• 0 to 10 V, 0	User
		when A575 is
		5A5A hex.)			directly, with-	to 5 V, 1 to
					out using the	5 V: FF38 to
					Adjustment	00C8 hex
					Value Incre-
A573	00 to 15			Gain Value Monitor		• −10 to 10 V:
					ment/Decre-
						1194 to
					ment Bits.
						157C hex
						• 0 to 10 V, 0
						to 5 V, 1 to
						5 V: 0ED8 to
						1068 hex
A574	00 to 15		Analog Inputs	Number of Average	Indicates the number of val-		User
				Value Samples in	ues to be averaged to obtain
				Adjustment Mode	the Offset/Gain Value Moni-
					tor values in adjustment
					mode. The number of sam-
					ples can be set between
					0000 and 0040 hex (0 to 64).
					Set this parameter before
					turning ON the Adjustment
					Enable Bit.
A575	00 to 15	Adjustment Mode Password		5A5A hex: Adjustment mode enabled.			User
				Other value: Adjustment mode disabled.

221