Omron FQM1-MMP21, FQM1-CM001, FQM1-MMA21 Section, Word Bits Function Settings Controlled

Analog Input Functions						Section 7-9
Auxiliary Area
Word	Bits	Function			Settings		Controlled
							by
A550	00 to 15	Analog Input PV		Contains the value input from the analog input port			Motion
				(using either the END refresh or immediate refresh)			Control
				in 4-digit hexadecimal.			Module
				The PV range depends on the input range:
				• 0 to 10 V:	FE70 to 20D0 hex
				• 0 to 5 V or 1 to 5 V:	FF38 to 1068 hex
				• −10 to 10 V:	DDA0 to 2260 hex
A552	00	Analog Input	Analog Input	User Adjustment	OFF: Not adjusted
		Status		Completed	ON:	Adjustment completed
	01 to 06			Reserved
	07			Analog Sampling	OFF: Not started
				Started	ON:	Started
	08			Factory Adjustment	OFF: No Error
				Data Error	ON:	Error
						(Checked at startup.)
	09			User Adjustment	OFF: No Error
				Data Error	ON:	Error
						(Checked at startup.)
	10 to 14	Reserved					---
	15	Analog Input	Analog Input	Analog Sampling	OFF: Normal sampling		Motion
		Status		Overlap	ON:	The next sampling	Control
							Module
						operation occurred
						before the present
						sampling operation
						completed.
A559	01 to 15	Analog Input	Analog Input	Number of Samples	Indicates the number of data		Motion
		Status			samples actually input since		Control
					sampling started.		Module
A560	00 to 15	Analog Out-	When an END refresh is selected, the 4-digit hexadecimal value set				With imme-
		put 1 Output	here by the user is output from analog output port 1.				diate
		Value	When immediate refreshing is selected, the 4-digit hexadecimal value				refresh:
							Motion
			being output from analog output port 1 is stored here for monitoring.
							Control
			The output value range depends on the output range, as shown below.
			• 0 to 10 V, 0 to 5 V or 1 to 5 V: FF38 to 1068 hex				Module
							With END
			• −10 to 10 V: EA84 to 157C hex
							refresh:
			Note
							User
			1. Set the analog output method (END or immediate refreshing) with the
			System Setup’s output method setting. A setting of 0 hex specifies an
			END refresh. This setting applies to both analog output 1 and 2.
			2. Specify the output range with the output 1 setting.
A561	00 to 15	Analog Out-	This word has the same settings as the analog output 1 output value
		put 2 Output	(A560), above. (When an END refresh is selected, set the value to out-
		Value	put from analog output port 2. When an immediate refresh is selected,
			the output value is stored here for monitoring.)
			Note
			1. Set the analog output method (END or immediate refresh) with the
			System Setup’s output method setting. A setting of 0 hex specifies an
			END refresh. This setting applies to both analog output 1 and 2.
			2. Specify the output range with the output 2 setting.

219