Omron FQM1-CM001 Installation, Section, 2 3. Lock the pins on the backs of the Modules

Installation Section 3-1

2.Fit the back of the FQM1 onto the DIN Track by inserting the FQM1 onto the top of the Track and then pressing in at the bottom of the FQM1, as shown below.

1

DIN Track

2

3. Lock the pins on the backs of the Modules.

PA202 POW ER

	L1
AC100
-240V
IN	PUT
	L2/N
	NC
	NC

									MMP2	1
									A1
									B1
									A2
								RDY	B2
								RUN
								ERR
				CM001				OUT
								0
						IN		1	2
								2
							0	3
						F	1	4
		RDY		2	OF		3	6
		RUN		1			4	7
FLEXIBLE		ERR					5
		PHL					6
CONTROLLER	COM		2				8
MOTION	PR		M1				7
	COMM				2		109
							11
		HER		AL					CN2
PERIP								25
						1
					CN1			CN1
PORT									40
									20
					RS422			1
						1
					40
				20

DIN Track mounting pins

4.Install a DIN Track End Plate on each end of the FQM1. To install an End Plate, hook the bottom on the bottom of the track, rotate the Plate to hook the top of the Plate on the top of the track, and then tighten the screw to lock the Plate in place.

2

1

End Plates

58