Omron FQM1-CM001, FQM1-MMA21 Details on System Setup Settings, Appendix C, Startup Mode

System Setup, Auxiliary Area Allocations, and Built-in I/O Allocations						Appendix C
Address	Bits	Function			Remarks		When setting
							is read
+330 to 331	00 to 15	High-speed	Absolute offset		8000 0000 to 7FFF FFFF hex		Immediately
		counter 1 (Counter			Application origin when using an absolute encoder.
		1)
+332 to 333	00 to 15	High-speed	Absolute offset		Same as high-speed counter 1.
		counter 2 (Counter
		2)
CX-Programmer: Analog Input/Output Tab Page
Address	Bits	Function			Remarks	When setting is read
+350	00 to 03	Analog I/O	Input method	0 hex: END refresh		At power ON
				1 hex: Immediate refresh (using PRV(881)
				instruction)
	04 to 07		Output method	0 hex: END refresh (Analog value output to
				A560 and A561 after executing END(001).)
				1 hex: Immediate refresh (using instructions)
				(Analog value output when SPED(885) or
				ACC(888) is executed.) (A560 and A561 are
				used for monitoring.)
+351	00 to 07	Analog input	Input range	00 hex: −10 to 10 V		At power ON
				01 hex: 0 to 10 V
				02 hex: 1 to 5 V (4 to 20 mA)
				03 hex: 0 to 5 V
+353	00 to 07	Analog output 1	Output range	00 hex: −10 to 10 V		At power ON
				01 hex: 0 to 10 V
				02 hex: 1 to 5 V
				03 hex: 0 to 5 V
				5A hex: Output disabled (Can be used to
				shorten I/O refresh time.) (See note.)
	08 to 11		Output stop func-	0 hex: Clear
			tion	1 hex: Hold
				2 hex: Maximum value
+354	00 to 07	Analog output 2	Output range	Same as for analog output 1.
	08 to 15		Output stop func-
			tion

Note Analog outputs that are not being used can be disabled to decrease the cycle time.

Details on System Setup Settings

Startup Mode

This setting determines the operating mode that will be used when the power supply to the Coordinator Module is turned ON.

System Setup mode setting disabled	RUN mode
System Setup mode setting enabled	Program: PROGRAM mode
	Monitor:	MONITOR mode
	Run:	RUN mode

Note The Coordinator Module will start in RUN mode unless the Startup Mode setting in the System Setup is enabled.

Peripheral Port Settings

The standard settings are for Host Link Mode, 1 start bit, 7-bit data, even parity, 2 stop bits, and 9,600 baud. Change the System Setup if any other settings are required.

RS-232C Port Settings (Host Link Port)

The standard settings are for Host Link Mode, 1 start bit, 7-bit data, even parity, 2 stop bits, and 9,600 baud. Change the System Setup if any other settings are required. If no-protocol communications are to be used, be sure to change the frame format.

325