Omron FQM1-CM001 Appendix C, RS-422APort Settings CX-Programmer:Drive Tab Page, Send Delay Time

System Setup, Auxiliary Area Allocations, and Built-in I/O Allocations					Appendix C
RS-422A Port Settings (CX-Programmer: Drive Tab Page)
RS-422A Port Settings for Serial Gateway
Standard/Custom Setting
Address		Settings	Function	Related flags and	When setting is
				words	read
Word	Bits
+360	15	0: Standard settings	The standard settings are for 1 start bit,	A414.15 (RS-422A Port	---
		Default: 0	7-bit data, even parity, 2 stop bits, and	Settings Changing Flag)
			9,600 baud.
Serial Communications Mode
Address		Settings	Function	Related flags and	When setting is
				words	read
Word	Bits
+360	08 to 11	00 or 09 hex: Serial Gateway	This setting determines whether the	A414.15 (RS-422A Port	At next cycle (Also
		Default: 00 hex	RS-422A port will operate in Serial	Settings Changing Flag)	can be changed
			Gateway mode or another serial com-		with STUP (237).)
			munications mode. Set 00 or 09 for
			Serial Gateway Mode.
RS-422A Response Timeout Time (RS422 Response Timeout of Command)
Address		Settings	Function	Related flags and	When setting is
				words	read
Word	Bits
+367	00 to 15	0001 to 00FF hex:	Sets the timeout time for a response	A414.15 (RS-422A Port	At next cycle (Also
		0.1 to 25.5 s	from the Servo Driver.	Settings Changing Flag)	can be changed
		Default: 0000 hex (5 s)			with STUP (237).)

RS-422A Port Settings for No-protocol Communications (Non-procedural)

Serial Communications Mode

Address		Settings	Function	Related flags and	When setting is
				words	read
Word	Bits
+360	08 to 11	03 hex: No-protocol	This setting determines whether the	A414.15 (RS-422A Port	At next cycle (Also
		Default: 00 hex	RS-422A port will operate in no-proto-	Settings Changing Flag)	can be changed
			col mode or another serial communica-		with STUP (237).)
			tions mode. Set 03 for No-protocol
			Mode.

Send Delay Time

Address		Settings	Function	Related flags and	When setting is
				words	read
Word	Bits
+362	00 to 15	Send delay time, 0 to 99,990	When TXD(236) is executed, data will	A414.15 (RS-422A Port	At next cycle (Also
		ms	be sent from the RS-422A port after the	Settings Changing Flag)	can be changed
		(0000 to 270F hex,	delay time set here.		with STUP (237).)
		unit: 10 ms)
		Default: 0000 hex

319