Omron FQM1-MMP21, FQM1-CM001, FQM1-MMA21 operation manual Non-fatal Errors, C2FF, Lit Flashing

Error Processing				Section 9-2
Error	Error	Auxiliary Area	Probable cause	Possible remedy
	code (in	flag and word
	A400)	data
I/O Table	80E0	A401.10: I/O	More than 5 Modules are connected.	Check whether the number of Modules is
Setting		Setting Error		incorrect. If the number of Modules is
error		Flag		incorrect, turn OFF the power supply and
				correctly connect the Modules.
Cycle	809F	A401.08: Cycle	The cycle time has exceeded the	Change the program to reduce the cycle
Time		Time Too Long	maximum cycle time (watch cycle	time or change the System Setup’s maxi-
Overrun		Flag	time) set in the System Setup.	mum cycle time setting.
error				One way to reduce the cycle time is by
				jumping parts of the program that aren’t
				being used.
System	C101 to	A401.06: FALS	FALS has been executed in the pro-	Remove the cause of the user-defined
FALS error	C2FF	Error Flag	gram.	error indicated by the FAL number.
			The error code in A400 will indicate
			the FAL number. The leftmost digit of
			the code will be C and the rightmost
			3 digits of the code will be from 101
			to 2FF hex, which correspond to FAL
			numbers 001 to 511.

Non-fatal Errors

If the following LED indicator condition appears during operation (in RUN or MONITOR mode), it indicates that a non-fatal error has occurred..

Power Supply			Module Indicators
Unit Indicators
POWER	RDY	RUN	ERR	PRPHL	COMM1	COMM2
Lit	Lit	Lit	Flashing	---	---	---

The non-fatal error’s error contents will be displayed in the Error Tab in the CX-Programmer’s Error Window. Determine the cause of the error from the error message and related Auxiliary Area flags/words and correct the cause of the error.

Errors are listed in order of importance. When two or more errors occur at the same time, the more serious error’s error code will be recorded in A400.

Non-fatal Errors

Error	Error	Flag and word	Probable cause	Possible remedy
	code (in	data
	A400)
System FAL	4101 to	A402.15: FAL	FAL has been executed in program.	Remove the cause of the user-
error	42FF	Error Flag	The error code in A400 will indicate	defined error indicated by the FAL
				number.
			the FAL number. The leftmost digit of
			the code will be 4 and the rightmost
			3 digits of the code will be from 101
			to 2FF hex, which correspond to FAL
			numbers 001 to 511.
System Setup	009B	A402.10: Sys-	There is a setting error in the Sys-	Set the correct value in the System
error		tem Setup Error	tem Setup. The location of the error	Setup.
		Flag	is written to A409.
		A409: System
		Setup Error
		Location
Motion Control	0300	A402.05: Motion	An error occurred during cyclic	Turn the power OFF and ON again.
Module Moni-		Control Module	refreshing with the Motion Control
toring error		Monitoring Error	Module.
		Flag

249