TallyGenicom Intelliprint 8008N Color Laser Printer User Guide
7.3 Periodical Replacement Parts
Some of the component parts of the printer, which become worn or deteriorat- ed according to the amount of usage (or ellapsed time of use) must be periodi- cally replaced at the expense of the printer's owner. Such component parts are referred to as “periodical replacement parts”. Normally a service engineer should replace these parts available as a service kit. Contact your dealer or ser- vice representative.
No. | Periodic replacement Parts | To be replaced with | Available as |
|
|
|
|
2 | Transfer roller | 120,000 Pages | Service Kit |
|
|
|
|
3 | Transfer belt cleaning roller | 120,000 Pages | Service Kit |
|
|
|
|
4 | Paper Feed Roller | 120,000 Pages | Service Kit |
|
|
|
|
5 | Separator Pad | 120,000 Pages | Service Kit |
|
|
|
|
zSince the lifespan of periodical replacement parts depends on how they are used, there may be cases when replacement is required earlier than the above schedule.
zContinued use of a periodical replacement part beyond its lifespan not only causes print quality problems or media jams but also could lead to hardware failure.
In some circumstances the Transfer roller and Transfer belt cleaner can be re- placed by a user but an engineer has to fit the feeder roller. A brief outline of replacing these parts is given below but please contact your service center for more details.
Transfer Belt cleaner replacement
Power the printer off. See “Chapter 6 Troubleshooting and Maintenance”.
Transfer roller replacement
1.Power the printer off.
2.Open the back cover of the printer.
3.Hold the white 2 plastic clips in slightly, raise and remove the transfer roller when the angle of the assembly allows the removal of the unit from the slots.
CAUTION! Be careful of the serrated edges on the unit.
4.Replace the unit with a new part ensuring that you are inserting it the cor- rect way up, metal plate uppermost, and angle the unit first to allow the shaft to fit the slot on both sides before lowering the white plastic parts down to be locked into position.
