Repair Information

If a problem occurs and a corresponding message displays, go to "MAP 0000: Start MAP" on page 2-7to isolate the problem. If no error occurs, the Send Firmware confirmation box displays.

8. Click Yes. The Send Firmware dialog box displays.

As the download begins, a Sending Files message displays at the top of the dialog box. This message remains for a few moments as a progress bar travels across the dialog box to show percent completion of the download. As the download progresses, a Writing data to FLASH message displays. This message remains as the progress bar continues to travel across the dialog box. The bar progresses to 100% when the last file is transmitted to the CTP card. The switch then performs an IPL, during which the switch-to-HAFM server link drops momentarily and the following occur at the product manager application:

—As the network connection drops, the Status table turns yellow, the Status field displays No Link, and the State field displays a reason message.

—The alert panel at the bottom of the navigation control panel displays a grey square, indicating switch status is unknown.

—Illustrated FRUs in the Hardware View disappear, and appear again as the connection is re-established.

After the IPL, a Send firmware complete message displays as shown below.

9. Click Close to close the dialog box.