HP C4200 manual Pack the HP All-in-One

HP warranty and support

Chapter 14

Call HP Korea customer support

Prepare the HP All-in-One for shipment

If after contacting HP Customer Support or returning to the point of purchase you are requested to send the HP All-in-One in for service, make sure you remove and keep the following items before returning your device:

•The print cartridges

•The power cord, USB cable, and any other cable connected to the HP All-in-One

•Any paper loaded in the input tray

•Any originals loaded in the HP All-in-One

To remove print cartridges before shipment

1.Turn on the HP All-in-One and wait until the print carriage is idle and silent. If the HP All-in-One will not turn on, skip this step and go to step 2.

2.Open the print cartridge door.

3.Remove the print cartridges from their slots.

NOTE: If the HP All-in-One does not turn on, you can unplug the power cord and then manually slide the print carriage to the far right side to remove the print cartridges.

4.Place the print cartridges in an airtight plastic container so they will not dry out, and put them aside. Do not send them with the HP All-in-One unless the HP customer support call agent instructs you to.

5.Close the print cartridge door and wait a few minutes for the print carriage to move back to its home position (on the left side).

NOTE: Make sure the scanner is idle and has returned to its parked position before turning off the HP All-in-One.

6.Press the On button to turn off the HP All-in-One.

Pack the HP All-in-One

Complete the following steps once you have removed the print cartridges, turned off the HP All-in- One, and unplugged it.

140 HP warranty and support