ASSEMBLING YOUR TILT-HEAD STAND MIXER

ENGLISH

To Operate Speed Control

Speed control lever should always be set on lowest speed for starting, then gradually moved to desired higher speed to avoid splashing ingredients out of bowl. See page 15 for Speed Control Guide.

To Lock Motor Head

1.Make sure motor head is completely down.

2.Place locking lever in LOCK position.

3.Before mixing, test lock by attempting to raise head.

To Unlock Motor Head

1.Place lever in UNLOCK position.

NOTE: Motor head should always be kept in LOCK position when using mixer.

Speed Control

Lock Unlock

USING YOUR POURING SHIELD*

To Attach Pouring Shield

1.Turn speed control to OFF.

2.Unplug Stand Mixer or disconnect power.

3.Attach Flat Beater, Dough Hook, or Wire Whip and bowl (see page11).

4.From the front of the mixer, slide the Pouring Shield over the bowl until the shield is centered. The bottom rim of the shield should fit within the bowl.

To Remove Pouring Shield

1.Turn speed control to OFF.

2.Unplug Stand Mixer or disconnect power.

3.Lift the front of the Pouring Shield clear of the bowl rim and

pull forward.

4.Remove attachment and bowl.

Pouring Chute

To Use Pouring Shield

1.For best results, rotate the shield so the motor head covers the “u” shaped gap in the shield. The pouring chute will be just to the right of the attachment hub as you face the mixer.

2.Pour the ingredients into the bowl through the pouring chute.

* If Pouring Shield is included.

12