Lucent Technologies 555-661-140 manual Merlin Legend Communications System Release

MERLIN LEGEND Communications System Release 6.1	Issue 1
Installation 555-661-140	August 1998
Installing the PC, CAT, or Printer	Page 5-14
Connecting a Printer to the Control Unit

To make the connections at the printer, follow the steps below. See

Figure 5-4 on page 5-13.

! At the printer location, either plug one end of a D6AP cord into a 2012D-50M transformer or follow the instructions in Step 9 above.

! Plug the other end of the D6AP cord into the lower jack on a 400B2 power adapter.

! Plug the 400B2 power adapter into the wall jack.

! Plug the 2012D-50M (or 2012D) transformer into the wall outlet for the printer.

! Plug one end of a second D8W cord into the top jack on the second 400B2 power adapter.

! Plug the other end of the second D8W cord into the WALL jack on the Z3A2 ADU.

! Connect the 25-pin male connector on the Z3A2 ADU to the 25-pin female end on a second 355AF adapter.

! Plug one end of a third D8W cord into the second 355AF adapter.

! Plug the other end of the third D8W cord into the SMDR jack on the back of the CAT.

! Plug one end of a fourth D8W cord into the PRINTER jack on the back of the CAT.

! Plug the other end of the fourth D8W cord into a third 355A adapter.

! Slide the third 355A adapter into the serial port on the back of the printer.

! Set the appropriate printer options for SMDR.

See “Setting Printer Options and DIP Switches” on page 5-21 for instructions.