Lucent Technologies 555-661-140 manual Replacing the Control Unit Housing, Release 2.0 or Earlier

MERLIN LEGEND Communications System Release 6.1	Issue 1
Installation 555-661-140	August 1998
Upgrading the System	Page 9-20
Replacing the Control Unit Housing

Replacing the Control Unit Housing

See Chapter 2, “Installing the Control Unit,” for instructions on replacing the control unit housing for Release 2.1 and later.

Release 2.0 or Earlier

To install the control unit housing, follow the steps below.

! Place the front panel(s) face down.

! If you are housing more than one carrier, connect the front panels together.

a.Line up the arrows.

b.Slide the panels until the semicircles form a complete circle. See Figure 9–8.

! Connect the side panels to the front panel(s) in the same way.

! Pick up the housing and place it on the control unit. If the system has more than one carrier, make sure you hold the housing only from the basic carrier side; otherwise, the housing can disassemble.

a.Line up the wire clips that are attached to the carrier with the recesses on the outside of the side panels.

b.Push back the panels until the clips hook over the tabs and rest in the recesses.