Lucent Technologies 555-661-140 Initializing and Testing the System, Initializing the System

MERLIN LEGEND Communications System Release 6.1		Issue 1	Issue 1
Installation 555-661-140		August 1998August 1998
Initializing and Testing the System
Initializing the System		Page 7-1
	Initializing and Testing the System	7

When you have finished installation, you are ready to initialize the system as described in this chapter.

Initializing the System

To initialize a Release 6.1 system, use one of the following methods:

■Restore from a 6.1 system programming disk or Translation memory card.

■Upgrade to Release 6.1 from Release 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 4.0, 4.1, 4.2, 5.0, or 6.0. See Chapter 9, “Upgrading the System.”

■Use system programming forms and the procedures from one of the guides listed in the next section, “Programming Guides.”

This section describes how to restore the system from the Translation memory card or the system programming disk.

NOTE:

On initial installations, make sure you perform a System Erase (frigid start), as described in Maintenance and Troubleshooting, either immediately before you restore from a disk or memory card or before you program the system. Failure to perform the System Erase (frigid start) can result in incorrect programming.