Lucent Technologies 555-661-140 manual Mounting Surface

MERLIN LEGEND Communications System Release 6.1	Issue 1
Installation 555-661-140	August 1998
Installing the Control Unit	Page 2-19
Installing the Basic Carrier

To install the basic carrier, follow the steps below:

! Mark the screw-hole locations on the backboard, using the basic carrier or the template supplied with the plastic preassembled backboard as a guide. See Figure 2–5.

Make sure the carrier is level before marking the holes.

! Drill a pilot hole in the center of each of the four screw-hole marks.

! Anchor the screws approximately halfway into the backboard.

! Position the carrier on the screws and slide the carrier to the left.

! Tighten the screws.

	Mounting Surface
Mounting	Backboard
Screw
	Basic
	Carrier

Figure 2-5. Marking the Basic Carrier Screw Holes