Lucent Technologies 555-661-140 manual Programming the System, Upgrading the System

MERLIN LEGEND Communications System Release 6.1	Issue 1
Installation 555-661-140	August 1998
Introduction	Page 1-4
Programming the System

■Form 2c, System Numbering: Line/Trunk Jacks

■Form 3a, Incoming Trunks: Remote Access

■Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)

■Form 3d, Incoming Trunks: DID

Connecting Data Equipment

The following forms indicate the data equipment you will need to set up data stations.

■Data Form 1a, Modem Data Station

■Data Form1b, 7500B Data Station

■Data Form 2, Data Hunt Groups

Programming the System

If you have a system programming disk created with SPM or a Translation memory card, you do not need to program the system. Instead, you can use the disk or memory card to restore the system; see Chapter 7, “Initializing and Testing the System,” for instructions. If you did not receive a disk or a memory card and it is your responsibility to program the system, see System Programming for instructions.

Upgrading the System

If you are upgrading to Release 6.1 from Release 6.0, 5.0, 4.2, 4.1, 3.1, 3.0, 2.1, 2.0, 1.0, 1.1, or from the MERLIN®II Communications System, refer to Chapter 9, “Upgrading the System,” then Chapter 7, “Initializing and Testing the System,” for upgrade instructions.