Lucent Technologies 555-661-140 manual Setting the Time and Date, Testing the System

MERLIN LEGEND Communications System Release 6.1	Issue 1
Installation 555-661-140	August 1998
Initializing and Testing the System	Page 7-3
Setting the Time and Date

! Use SPM and the system programming disk to perform the Restore procedure.

See System Programming and Maintenance (SPM) for instructions.

NOTE:

You must restore the system using either the system programming (or backup) disk or memory card whenever a frigid start (System Erase) occurs.

Setting the Time and Date

If the Control Unit Diagram indicates that you should set the time and date, do so before you test the system.

Follow this procedure:

Menu: 6\V3URJ→6\VWHP→'DWH→'URS→Dial current date→(QWHU

See System Programming if you need additional instructions.

Testing the System

Once you have initialized the system, it is ready for system acceptance testing. Perform the basic tests below to test trunks, telephones, and features.

If any equipment is not working properly, see Maintenance and

Troubleshooting for troubleshooting instructions.

Testing MLX Telephones

This switch-based software test verifies that the LEDs, ringer, buttons, switchhook, and B-channel operation for MLX telephones are working correctly. You cannot run this test when the telephone is in