Lucent Technologies 555-661-140 manual Coverage Test, Testing the DSS, Testing Night Service

MERLIN LEGEND Communications System Release 6.1	Issue 1
Installation 555-661-140	August 1998
Initializing and Testing the System	Page 7-16
Testing the System

Coverage Test

To verify that coverage is in effect, follow the steps below:

! Have someone call the covered telephone.

! Count the number of rings at the covered telephone before the covering telephone starts ringing.

This should be the same as the programmed number of rings.

! Pick up the handset at the covering telephone and verify that you have good two-way communication.

! Hang up the handset at the covering telephone.

! Check both Individual and Group Coverage.

Testing the DSS

At each Direct Station Selector (DSS), check that all lights are operational. Then use the DSS to call a telephone in the system. Test the Page buttons on the DSS.

Testing Night Service

To test the Night Service feature on the system operator console, follow the steps below:

! At the system operator console, press the Night Service button.

If Night Service with Outward Restriction is programmed, you must also enter the password. (You can also activate Night Service on a DLC by pressing the Feature button and dialing ￿￿.)

The Night Service LED turns on.

! Pick up the handset and press a button for an outside trunk.

! Dial the outside number that reaches an operator console that is programmed to receive Night Service coverage.