Lucent Technologies 555-661-140 manual Testing BRI Trunks, Testing Selected System Features

MERLIN LEGEND Communications System Release 6.1	Issue 1
Installation 555-661-140	August 1998
Initializing and Testing the System	Page 7-13
Testing the System

! When the person answers, verify that you have good two-way communication, then hang up.

The green LED should turn off, the red LED should turn off, and another red LED may turn on.

! Repeat Steps 1 through 4 for each outgoing or two-way

dial-repeating tie trunk.

Testing BRI Trunks

Perform the testing described in “800 NI-BRI Module Problems” in

Chapter 4 of Maintenance and Troubleshooting.

Testing Selected System Features

This section provides procedures to test the following system features:

■Automatic Route Selection (ARS). For Hybrid/PBX mode only. Use the same test for Idle Line Preference, a similar feature used in Key mode only. Use the same test for Station Message Detail Recording (SMDR), as explained in the test procedure. Refer to Planning Forms 3e, 3f, and 3g for ARS information.

■Group Calling. Use the same test for the Listed Directory Number (the QCC queue), which is for Hybrid/PBX only. Use the same test for Group Paging. Refer to Planning Form 7d for Group Calling information.

■Coverage. Refer to Planning Form 7c for Group Coverage information.

If any feature does not work properly, check system programming. You can run these tests easily from an MLX telephone or an analog multiline telephone.