NEC 1080Xd 35. HC Subcommands cont’d, Service Processor, arg1, arg2, arg3, arg4, Description

Table 3-35. HC Subcommands (cont’d)

cmd	arg1	arg2	arg3	arg4	Description
ncconn	-	-	-	-	Used to set connection information of the 1.6G
					cable.
					Displays Help for “ncconn” when the argument
					is omitted or an error is made.
					This subcommand can be executed when all
					partitions are in the DC POWER OFF state.
	xbcx	nciy	iors	ncit	Specifies the connection between the 1.6G port
					with the port number y in the XBC chip with the
	iors	ncit	xbcx	nciy	physical number x and the 1.6G port with the
					port number t in the IOR chip with the physical
					number s.
					t must be (0).
ncdis	-	-	-	-	Used to disconnect the 1.6G cable.
					Displays Help for “ncdis” when the argument is
					omitted or an error is made.
					This subcommand can be executed when all
					partitions are in the DC POWER OFF state.
	xbcx	nciy	-	-	Removes the connection of the 1.6G port with
					the port number y in the XBC chip with the
					physical number x.
					It is linked to the disconnection of the
					corresponding port (and vice versa).
	iors	ncit	-	-	Removes the connection of the 1.6G port with
					the port number t in the IOR chip with the
					physical number s. t must be (0).
					It is linked to the disconnection of the
					corresponding port (and vice versa).
led	-	-	-	-	Used to turn on/off a component’s LED to
					identify its location.
					Displays Help for “led” when the argument is
					omitted or an error is made.
					For execution on XBC (XIC Board/XBR Board)
					and CELLV Board, one of the partitions must be
					in the DC POWER ON state.
					For execution on the PCIX, no condition is
					required.
					For execution on the PCI slot, the superior GXB
					must be in the online state.
	xbcx	onoff	-	-	Turns on/off the LED of the XIC Board/XBR
					Board.
					“x” is specified as below.
					0: XIC Board
					1: XBR Board

Service Processor 3-43