NEC 1080Xd 35. HC Subcommands cont’d, Service Processor, arg1, arg2, arg3, arg4, Description

Table 3-35. HC Subcommands (cont’d)

cmd

arg1

arg2

arg3

arg4

Description

enable		serialx	-	-	Enables the serial controller part within the XBC
(cont’d)					chip.
					“x” is the serial controller number (0-3).
					A partition requires a serial controller. When a
					partition contains plural CELLV Boards, a serial
					controller is selected from available serial
					controllers automatically.
	cellx	[all]	-	-	Enables the CELLV Board.
					“x” is the physical CELLV Board number (0-3).
					When the second argument is omitted, only the
					CELLV Board is enabled, and the states of any
					other subcomponents do not change. In this
					case, operation is rejected if some required
					components are disabled.
					When “all” is specified as the second argument,
					not only the CELLV Board but also its
					subcomponents become enabled.
		cxiy	-	-	Enables the XBC interface part within the
					CELLV Board.
					“y” is the interface part number (0-1).
					For information on the relationship between the
					CXI within the CELLV Board and the CXI within
					the XBC chip, refer to “cxix” of “xbcx” in
					“enable”.
	procxy	-	-	-	Enables the Processor.
					“x” is the physical CELLV Board number (0-3).
					“y” is the Processor number (0-3) within the
					CELLV Board .
	mmcxy	[all]	-	-	Enables the MMC.
					“x” is the physical CELLV Board number (0-3).
					“y” is the MMC number (0-1) within the CELLV
					Board.
					When the second argument is omitted, only the
					MMC is enabled, and the states of any other
					subcomponents do not change.
					When “all” is specified as the second argument,
					not only the MMC but also its subcomponents
					become enabled.
		rowz	-	-	Enables the ROW.
					“z” is the ROW number (0-3).
					DIMM is not controlled individually.
					DIMMs are automatically detected at the time of
					startup.

3-40 Service Processor