NEC 1080Xd manual HC Subcommands cont’d

Table 3-35. HC Subcommands (cont’d)

cmd	arg1	arg2	arg3	arg4	Description
loc	pbayxy	d	h	-	Specifies the location and height of the Power
(cont’d)					Bay Unit in the cabinet.
					“x” is the unit ID number.
					1: Power Bay Unit
					0: Not allowed
					“y” is the ID number. (0) must be specified.
					“d” is the position of the lower edge of the unit in
					decimal (0-63) by using the EIA unit.
					(1 EIA unit = 44.45mm)
					“h” is the height of the unit (3).
	pcixx	c	d		Specifies the location and height of the PCIX
					Unit in the cabinet.
					“x” is the PCIX Unit number (1-3).
					“c” must be (1).
					“d” is the position of the lower edge of the unit in
					decimal (0-63) by using the EIA unit.
					(1 EIA unit = 44.45mm).
check	-	-	-	-	Checks the current configuration information
					from the following points:
					• Presence of units whose location information
					is not entered
					• Presence of “DISABLE” components
					• Presence of “INVISIBLE” units
					Configuration violating the installation
					restrictions
					Configuration with penalty in
					performance/RAS.
					This subcommand can be executed in the AC
					POWER ON state or DC POWER ON state.

Service Processor 3-45