NEC 1080Xd manual Stabilizer and Pcix Unit Front Bezel

1.Check that the front stabilizer is in the pulled-out position. If not, remove the screw securing the stabilizer and pull it out (see Figure 5-10).

2.Remove the front bezel from the front of the PCIX unit by pulling it first from the bottom and then away from the top of the unit (see Figure 5-10).

B

A

AStabilizer

BPCIX Unit Front Bezel

Figure 5-10. Stabilizer and PCIX Unit Front Bezel

3.Remove the two screws (one on each side) securing the PCIX unit to the front of the cabinet (see Figure 5-11).

A

A Server Screws (2)

Figure 5-11. PCIX Unit Screws

I/O Board Installation 5-13