Nortel Networks 10BASE-T Describes the CI main menu options, Console Interface Main Menu options

		Using the Console Interface
	Table 3-1 describes the CI main menu options.
Table 3-1.	Console Interface Main Menu options
Option		Description
IP Configuration/		Displays the IP Configuration/Setup screen (see “IP Configuration/Setup” on
Setup...		page 3-8). This screen allows you to set or modify IP configuration parameters.
SNMP Configuration...		Displays the SNMP Configuration screen (see “SNMP Configuration” on
		page 3-13). This screen allows you to set or modify the SNMP read-only
		community and read-write community strings, enable or disable the
		authentication trap and the link Up/down trap, set the IP address of trap
		receivers, and set the trap community strings.
System		Displays the System Characteristics screen (see “System Characteristics” on
Characteristics...		page 3-15). This screen allows you to view switch characteristics, including
		number of resets, power status, hardware and firmware version, and MAC
		address. This screen also contains three user-configurable fields: sysContact,
		sysName, and sysLocation. When the switch is part of a stack configuration, this
		screen also displays the base unit identification, the number of units configured
		in the stack, and the local unit stack number.
Switch Configuration...		Displays the Switch Configuration Menu screen (see “Switch Configuration” on
		page 3-18). This menu provides the following configuration options: MAC
		Address Table, MAC Address-Based Security, VLAN Configuration, Port
		Configuration, MultiLink Trunk Configuration, Port Mirroring Configuration, Rate
		Limiting Configuration, IGMP Configuration, Display Port Statistics, and Clear All
		Port Statistics.
Console/Comm Port		Displays the Console/Comm Port Configuration screen (see “Console/Comm
Configuration...		Port Configuration” on page 3-94). This screen allows you to configure and
		modify the console/Comm port parameters, including the console port speed
		and password settings for the switch and stack operation.
Identify Unit Numbers		Appears only when the switch is participating in a stack configuration. When
		selected, this option identifies the unit numbering of each unit in a stack
		configuration by lighting the corresponding number of Link LEDs for
		approximately 10 seconds. For example, in a four-unit stack, unit 1 displays one
		Link LED, unit 2 displays two Link LEDs, unit 3 displays three Link LEDs, and
		unit 4 displays four Link LEDs. The LED display temporarily overrides any
		existing Link LED indications on all unit LED display panels.
Renumber Stack		Appears only when the switch is participating in a stack configuration. Displays
Units...		the Renumber Stack Units screen (see “Renumber Stack Units” on page 3-101).
		This screen allows you to renumber the units at any time.
Display Hardware		Displays the Hardware Unit Information screen (see “Hardware Unit Information”
Units...		on page 3-103). This screen lists the switch models, including any installed MDA
		and Cascade Modules.
		(continued)
309985-C Rev 00		3-5