Nortel Networks 10BASE-T Configuration File Download/Upload Screen Fields, Copy Configuration

Using the Console Interface

Table 3-43. Configuration File Download/Upload Screen Fields

FieldDescription

Configuration Image The file name you have chosen for the configuration file. Choose a meaningful

Filenamefile name that will allow you to identify the file for retrieval when required. The file must already exist on your TFTP server and must be read/write enabled.

Default	Zero-length string
Range	An ASCII string of up to 30 printable characters

TFTP Server IP Address The IP address of your TFTP load host.

	Default	0.0.0.0 (no IP address assigned)
	Range	Four-octet dotted-decimal notation, where each octet is
		represented as a decimal value, separated by a decimal point
Copy Configuration	Specifies whether to copy the presently configured switch/stack parameters to
Image to Server	the specified TFTP server (default is No).
	Use the spacebar to toggle the selection to Yes.
	Press [Enter] to initiate the process.
	Default	No
	Range	Yes, No
Retrieve Configuration	Specifies whether to retrieve the stored switch/stack configuration parameters
Image from Server	from the specified TFTP server (default is No). If you choose Yes, the download
	process begins immediately and, when completed, causes the switch/stack to
	reset with the new configuration parameters.
	Use the spacebar to toggle the selection to Yes.
	Press [Enter] to initiate the process.
	Default	No
	Range	Yes, No

Requirements

•The Configuration File feature can be used only to copy standalone switch configuration parameters to other standalone switches or to copy stack configuration parameters to other stack configurations.

For example, you cannot duplicate the configuration parameters of a unit in a stack configuration and use it to configure a standalone switch.

309985-C Rev 00 3-119