Nortel Networks 10BASE-T manual Switch Configuration Menu Screen Options

Using the Console Interface

Table 3-5.	Switch Configuration Menu Screen Options
Option		Description
MAC Address Table		Displays the MAC Address Table screen (see “MAC Address Table” on
		page 3-21). This screen allows you to view all MAC addresses and
		their associated port or trunk that the switch has learned, or to search
		for a particular MAC address (to see if the switch has learned the
		address).
MAC Address-Based Security...		Displays the MAC Address Security Configuration Menu (see “MAC
		Address-Based Security” on page 3-23). This menu provides the
		following options: MAC Address Security Configuration, MAC Address
		Security Port Configuration, MAC Address Security Port Lists, and
		MAC Address Security Table. This menu allows you to set up your
		MAC address-based security for your switch.
VLAN Configuration...		Displays the VLAN Configuration Menu (see “VLAN Configuration
		Menu” on page 3-39). This menu provides the following options: VLAN
		Configuration, VLAN Port Configuration, VLAN Display by Port, and
		Traffic Class Configuration. This menu allows you to create and modify
		VLANs.
Port Configuration...		Displays the Port Configuration screen (see “Port Configuration” on
		page 3-53). This screen allows you to configure a specific switch port,
		all switch ports or, when in a stack configuration, all stack ports.
High Speed Flow Control		Appears only when a gigabit MDA is installed in one of the units of a
Configuration...		stacked configuration. When the gigabit MDA is installed, selecting
		this option displays the High Speed Flow Control Configuration screen
		(see “High Speed Flow Control Configuration” on page 3-55).
MultiLink Trunk Configuration...		Displays the MultiLink Trunk Configuration Menu (see “MultiLink Trunk
		Configuration” on page 3-58). This menu provides the following
		options: MultiLink Trunk Configuration, and MultiLink Trunk Utilization.
		This menu allows you to create and modify trunks, and to monitor the
		bandwidth utilization of configured trunks.
Port Mirroring Configuration...		Displays the Port Mirroring Configuration screen (see “Port Mirroring
		Configuration” on page 3-65). This screen allows you to designate a
		single switch port as a traffic monitor for up to two specified ports or
		addresses.
Rate Limiting Configuration...		Displays the Rate Limiting Configuration screen (see “Rate Limiting
		Configuration” on page 3-69). This screen allows you to limit the
		forwarding rate of broadcast and IP multicast packets.

(continued)

309985-C Rev 00 3-19