Nortel Networks 10BASE-T manual Vlan Type, Protocol Id PID

		Using the Console Interface
Table 3-13.	VLAN Configuration Screen Fields (continued)
Field	Description
Delete VLAN	Allows you to delete a specified VLAN, except the assigned management VLAN
	(see Management VLAN field). Enter the number of the VLAN you want to delete,
	then press [Enter], or use the space bar to toggle through the selection until you
	reach the specific VLAN you want to delete, then press [Enter].
	The specified VLAN is deleted as soon as you press [Enter]. The software does not
	prompt you to reconsider this action. If you delete a VLAN, all configuration
	parameters that are associated with that VLAN are deleted also.
	You cannot delete VLAN 1. By default, all switch ports are assigned as untagged
	members of VLAN 1 with all ports configured as PVID = 1. See “IEEE 802.1Q VLAN
	Workgroups” on page 1-38 for more information.
	Default	blank field
	Range	2 to 4094
VLAN Name	Allows you to assign a name field to configured VLANs.
	Default	VLAN # (VLAN number)
	Range	Any ASCII string of up to 16 printable characters

Management VLAN Allows you to assign any VLAN as the management VLAN. VLAN 1 is the default management VLAN for the switch. To set this field, the VLAN State field value must be Active, and the VLAN Type field value must be Port-Based or Protocol-Based (with the Protocol Id (PID) Field value set to IpEther2).

	Default	Yes
	Range	Yes, No
VLAN Type	Allows you to select the type of VLAN (port-based or protocol-based) to create. To
	set this field, the VLAN State field value must be Inactive.
	Default	Port-Based
	Range	Port-Based, Protocol-Based
Protocol Id (PID)	Allows you to set the protocol type of your protocol-based VLAN (to set this field, the
	VLAN State field value must be Inactive). You can choose from any of 15 predefined
	supported protocols (see “Predefined Protocol Identifier (PID) Description” on
	page 3-45), or you can create your own user-defined protocol-based VLAN (see the
	User-defined PID field description for more information).
	Default	None
	Range	None, Ip Ether2, Ipx 802.3, Ipx 802.2, Ipx Snap, Ipx Ether2,
		AplTk Ether2Snap, Declat Ether2, DecOth Ether2, Sna 802.2,
		Sna Ether2, NetBios 802.2, Xns Ether2, Vines Ether2,
		Ipv6 Ether2, User-Defined, Rarp Ether2
		(continued)
309985-C Rev 00		3-43