Nortel Networks 10BASE-T manual High Speed Flow Control Configuration, LnkTrap, Autonegotiation

		Using the Console Interface
Table 3-19.	Port Configuration Screen Fields (continued)
Field	Description
Status	Allows you to disable any of the switch ports. You can also use this field to control
	access to any switch port.
	Default	Enabled
	Range	Enabled, Disabled
Link	A read-only field that indicates the current link state of the corresponding port, as
	follows:

•Up: The port is connected and operational.

•Down: The port is not connected or is not operational.

LnkTrap	Allows you to control whether link up/link down traps are sent to the configured trap
	sink from the switch.
	Default	On
	Range	On, Off
Autonegotiation	When enabled, sets the corresponding port speed to match the best service provided
	by the connected station (up to 100 Mb/s in full-duplex mode when a 10/100 MDA is
	installed). This field is disabled for all fiber optic ports.
	Default	Enabled
	Range	Enabled, Disabled
Speed/Duplex1	Allows you to manually configure any port to support an Ethernet speed of 10 Mb/s in
	half- or full-duplex mode. When a 10/100 MDA is installed, you can manually
	configure the MDA ports to support 10 Mb/s or 100 Mb/s in half- or full-duplex mode.
	Default	10Mbs/Half (when Autonegotiation is Disabled)
	Range	10Mbs/Half, 10Mbs/Full, 100Mbs/Half, 100Mbs/Full

1 Fiber optic ports can only be set to 100Mbs/Half or 100Mbs/Full.

High Speed Flow Control Configuration

The High Speed Flow Control Configuration screen (Figure 3-23) allows you to set the port parameters for any gigabit MDA that may be configured in a stack configuration.

Note: The BayStack 410-24T switch does not support gigabit MDAs; however, this screen will appear if the BayStack 410-24T switch is part of a stack configuration, and only if a gigabit MDA is installed in any stack unit.

309985-C Rev 00 3-55