Nortel Networks 10BASE-T manual Port Mirroring Address-Based Screen Example

Introduction to the BayStack 410-24T Switch

In this example, port 23 becomes the designated Monitor Port for switch S1 when you press [Enter] in response to the [Yes] screen prompt.

Note: The screen data displayed at the bottom of the screen changes to show the new currently active port mirroring configuration after you press [Enter].

The Monitoring Mode field [ Address A - > Address B ] indicates that all traffic transmitted by address A to address B will be monitored by the StackProbe attached to Monitor port 23.

Note: When you enter MAC addresses in this screen, they are also displayed in the MAC Address Table screen (see “MAC Address Table” on page 3-21).

Port Mirroring Configuration
Monitoring Mode:	[	Address A		-> Address B ]
Monitor Unit/Port:	[	/23 ]
Unit/Port X:	[	/	]
Unit/Port Y:	[	/	]

Address A: [ 00-44-55-44-55-22 ]

Address B: [ 00-33-44-33-22-44 ]

Is your port mirroring configuration complete? [ Yes ]

	Currently Active Port Mirroring Configuration
	---------------------------------------------
Monitoring Mode: -> Port X		or	Port Y ->	Monitor Port: 23
Port X: 25	Port Y: 24

Use space bar to display choices, press <Return> or <Enter> to select choice. Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.

Figure 1-54. Port Mirroring Address-Based Screen Example

309985-C Rev 00 1-87