4.25 Fluorescent Lamp | 4 Replacement Procedure |
4.Setting bezel
1)Hook the bezel on the five latches of the frame from the upper side.
NOTE: 1) Make sure the
2)Be careful not to damage the TAB.
3)Make sure the five latches of the upper side of bezel are hooked on.
(1)Install the bezel from the
TAB side. Be careful not to damage the TAB. Hook the bezel on the five latches.
Make sure the gum projection for protecting the cable is not outside th ebezel.
Make sure the fold of reflector 
is not outside the bezel. 
The cable shall not be outside the bezel.
(2)Align the bezel with the lamp side of the backlight unit.
Make sure the gum projection for protecting the cable is not outside th ebezel.
Figure 4-59 Replacing TOSHIBA fluorescent lamp (XGA) (9)
TECRA M1 Maintenance Manual |
