3.6 Keyboard Test

3 Tests and Diagnostics

To check only the USB mouse, follow the procedures below:

Connect the USB mouse to the computer’s USB connector.

Next, set up the computer’s hardware as follows:

PERIPHERAL

Internal Pointing Device = Simultaneous

USB Legacy Emulation = Enabled

Then, perform the Pointing Stick Diagnostic Test and make sure:

The cursor moves in the direction that you move the USB mouse.

The display reverses when you click the right button or left button

To stop this test, press the two IPS buttons on the computer at the same time. (You cannot use the USB mouse to stop the test.)

Subtest 05

USB Test

 

This Subtest checks USB. The USB TEST Module (ZD0003P01) and USB Cable

 

(ZD0003P02) must be connected to the computer.

 

The following message will appear. Select a port to test and press Enter.

 

Test port number select (1:Port0, 2:Port1, 3:Port2) ?

 

If the test ends successfully, OK is displayed. If nothing is displayed, there may be a

 

problem with the USB port. Check the wraparound connection and repeat the test.

Subtest 07

InTouch/Presentation key

 

When this subtest displays messages shown below in order, press the

 

corresponding button.

 

 

 

 

 

NOTE: This subtest must be completed within 10 seconds.

 

 

 

 

 

Press [ InTouch ] key

 

 

Press [ Presentation ] key

TECRA M1 Maintenance Manual (960-436)

3-19

Page 145
Image 145
Toshiba M1 manual ZD0003P02 must be connected to the computer