![](/images/new-backgrounds/1272369/272369507x1.webp)
4 Replacement Procedures | 4.6 Slim Select Bay Module |
Installing the Slim Select Bay Module
To install the slim select bay module, follow the steps below and refer to figures
1.Seat the plastic frame on the side of the slim select bay module, and secure it with the following screws.
∙ M2×3 SUPER FLAT screw | ×5 |
2. Install the connector and plastic brace and secure them with the following screws.
∙ M2×8 BIND screw | ×2 |
3.Slide the slim select bay module into the computer to connect it to PJ1511 on the system board.
4.Remove the following screw tightened when removing the slim select bay module. Then secure the removed screw in the next screw hole . (The slim select bay is locked.)
∙ M2.5×4 FLAT HEAD screw | ×1 |
TECRA M1 Maintenance Manual |