4.25 Fluorescent Lamp

4 Replacement Procedure

9.Install the protection cover S (A), protection cover G (B), aluminum tape (C) and fixing tape for lead wire (D). Use new parts.

Stick the protection covers in the order of (B), (A) to the standard line for fitting pin.

Stick the aluminum tape (C) following the sticking standards.

Long sides: Stick to the mark-off line of the lamp cover on the back of bezel.

Short sides: Stick to the edge of lamp cover.

Stick the fixing wire for lead wire following the sticking standards. Long sides: Stick to the outline of the LCD module.

Short sides: Stick so that the wire covers the screws.

(B) Protection cover G

(C) Aluminum tape

Latch

(D) Fixing tape for lead wire

(A) Protection cover S

Figure 4-70 Replacing Sharp fluorescent lamp (SXGA+) (9)

TECRA M1 Maintenance Manual (960-436)

4-109

Page 346
Image 346
Toshiba M1 manual Replacing Sharp fluorescent lamp SXGA+