
4.8 CPU |
| 4 Replacement Procedures |
M2.5×16 FLAT HEAD screw | A | M2.5×4 FLAT HEAD screw |
|
| |
|
| CPU cover |
M2.5×4 FLAT HEAD screw
Slot
Figure 4-11 Removing the CPU cover
2.Remove the following screws securing the CPU holder. Lift the “2” side of the CPU holder first, then rotate the holder 90 degrees counterclockwise. Then lift the “1” side of the CPU holder and remove the holder.
∙ M2×6 BIND screw | ×4 |
3. Remove the fin.
CAUTION: Silicon grease is applied between the fin and the CPU. When removing the fin, be careful not to damage the CPU under the fin.
TECRA M1 Maintenance Manual |