4.14 Bluetooth Module | 4 Replacement Procedures |
4.14 Bluetooth Module
Removing the Bluetooth Module
To remove the Bluetooth module, follow the steps below and refer to figure
CAUTION: Do not try to remove the Bluetooth module with the computer turned on. You can damage the computer or Bluetooth module. Do not touch the connectors on the Bluetooth module on the computer. Debris on the connectors may cause Bluetooth access problems.
1.Remove the Bluetooth coaxial cable (brown) from the Bluetooth module using an antenna coaxial cable disconnector.
2.Remove the following screw securing the Bluetooth module.
∙ M2×3 SUPER FLAT screw | ×1 |
3.Lift up the Bluetooth module and disconnect the Bluetooth SUMI card from PJ4900 on the system board.
4.Remove the Bluetooth SUMI card from the connector on the Bluetooth module.
TECRA M1 Maintenance Manual |
