Toshiba M1 manual Replacement Procedures Sensor/Switch Board, Removing the Sensor/Switch Board

4 Replacement Procedures 4.11 Sensor/Switch Board

4.11 Sensor/Switch Board

Removing the Sensor/Switch Board

To remove the sensor/switch board, make sure the computer is in boot mode and powered off, follow the steps below and refer to figure 4-19.

1. Remove the following screws securing the sensor/switch board.

∙ M2.5×2.8 FLAT HEAD screw ×2

2. Remove the sensor/switch board by lifting it up.

M2.5×2.8 FLAT HEAD screw Sensor/switch board SUMI card

Sensor/Switch Board

Figure 4-19 Removing the Sensor/Switch board

4-38 TECRA M1 Maintenance Manual (960-436)