ADTRAN ATLAS 800PLUS user manual Implement the Map

Chapter 6. Creating a Dedicated Map

2.Navigate to the Port index number of the second port and paste the configuration by pressing P. Repeat for the first port of the T1/PRI card located in Slot 1.

3.Navigate to the V.35 Port Configuration menu and repeat the configuration of the first port followed by copy and paste to the second and third ports.

Implement the Map

1.Navigate to the Dedicated Map menu and select Create /Edit Map. If desired, enter a name for the map by pressing Enter when the cursor is over Map Name. Type the desired name in the entry box.

2.Select the Connects submenu. Using Table 6-1 on page 6-2, define each of the connections necessary to route the bandwidth as desired. For the example, there will be a connection for each of the connections shown in Table 6-1 on page 6-2. The entries are made as follows (a completed map is shown in Figure 6-3).

A.Select the FROM Slot for Data A (i. e., Controller T1).

B.Select the FROM Port (i.e. Port 1 for T1-A Data).

C.Using the FROM Configuration submenu select the DS0s (i.e. 9-24 for Data A).

D.Select the TO Slot and TO Port the same way (V.35 in Slot2 / Port 1 for Data A).

E.Using the Configuration submenu, set the V.35 to operate at 56k / 64k per DS0.

F.Repeat for the remaining Data connections (i. e., Data B and Data C).

G.Insert new connection lines by typing I with the cursor over the Index # of the first connection.

H.Copy the first connection by pressing C with the cursor on the Index #.

I.Paste this onto a new connection line by typing P with the cursor over the index numbers of the new connections.

J.Modify these connection lines to complete the connections for data.

K.Select the FROM Slot and FROM Port for the first voice connection (i. e., Slot 0/Port 1 for T1-A Voice).

L.Repeat step C to select the voice DS0s (i. e., 1 through 8 for Voice A).

M.Select the TO slot/Port (PBX Connection) as in D above (i. e., Quad T1/ PRI in Slot 1/Port 2).

N.Using the Configuration submenu, set the starting DS0 that these voice DS0s will appear in (i. e., 1 for Voice A; 9 for voice B; 17 for Voice C). This sets the DACSing between the T1s.

61200226L1-1 ATLAS 800 PLUS User Manual 6-3