Chapter 5. Using the Terminal Menu
Interface Configuration
The Interface Configuration option for the Dial Plan menu sets configuration param- eters for the end point. These parameters vary by the type of port selected. The following sections describe the configuration options for each available type of module and port that existed when this manual was released. Configuration information for specific modules is also located in the manual for each module. If configuration information for a particular module you are using is not described in the following sections, please refer to the module manual for information on the interface parameters.
Quad T1/PRI Module Interface Configuration
This section describes the Network Termination and User Termination configura- tion settings for the Quad T1/PRI module when using the Dial Plan menus.
Quad T1/PRI Module (Network Termination/PRI)
When you are working in the Network Termination section of the Dial Plan menu, the Slot is defined as a T1/PRI module, and Sig is set to PRI, the following config- uration options are available:
Switch Type
Write security: 2; Read security: 5
Defines the type of PRI switch that ATLAS is connected to. If connected to another ATLAS, both need to be set to the same type. The following options are available:
•Lucent 5E
•Northern DMS 100
•National ISDN
•AT&T 4ESS
First DS0
Number of DS0s
Write Security: 3 Read Security: 5
These two items permit fractional PRI to be defined. These menu items define the first active DS0 and the number of DS0s used for calls on this PRI. DS0 24 is assumed to be used by the PRI for the “D” channel.
Outgoing Number Conversion
Write Security: 3 Read Security: 5
This item defines the rules for converting
As dialed
ISDN -
National pref
ISDN - Subscriber pref
ISDN - National DMS Reserved pref
Send digits provided as unknown number type.
Convert to ISDN type, using the
Convert to ISDN type, using the
Send digits provided as National Number Type, DMS Reserved Numbering Plan.
| ATLAS 800PLUS User Manual |
