ADTRAN ATLAS 800PLUS user manual Ethernet 10BaseT Connection, MON Monitor, Network Pinout

Chapter 2. Installation

Table 2-3. Network Pinout

PIN NAME DESCRIPTION

1R1 RXDATA-RING Receive data from the network

2	T1 RXDATA-TIP	Receive data from the network
3	UNUSED	—
4	R TXDATA-RING	Send data toward the network
5	T TXDATA-TIP	Send data toward the network
6,7,8	UNUSED	—

Ethernet 10BaseT Connection

The 10BaseT port (RJ-48C) provides an Ethernet LAN connection, which is used for TFTP, SNMP, and Telnet connection. See Table 2-4 on page 2-6 for the pinout.

Connection

The network connection is as follows:

Connector type	(USOC) RJ-48C
Part number	AMP# 555164-2

Table 2-4. Ethernet 10BaseT Pinout

PIN	NAME	DESCRIPTION
1	TX1	Transmit Positive
2	TX2	Transmit Negative
3	RX1	Receive Positive
4 & 5	UNUSED	—
6	RX2	Receive Negative
7 & 8	UNUSED	—

MON (Monitor)

The MON test jack provides a bridged access jack for non-intrusive monitoring of the T1 circuits receiving data. When connected to this jack, the test equipment should be configured for a bridged termination.

2-6 ATLAS 800PLUS User Manual 61200226L1-1