Chapter 9. SNMP Management
DS1 ALERT TRAPS
RFC1406 also defines a series of Current and Total Alert threshold values. You can enable the ATLAS to send an Alert Trap message to each member of the Trap Des- tination List when accumulated error statistics exceed these threshold values.
Table
Table 9-4. DS1 Current Alert SNMP Trap
Current Alert | Severity | Description |
|
|
|
adATLAS800CurrentES | WARNING | the current interval errored second threshold has been |
|
| exceeded |
|
|
|
adATLAS800CurrentSES | WARNING | the current interval severely errored second threshold |
|
| has been exceeded |
|
|
|
adATLAS800CurrentSEFS | WARNING | the current interval severely errored framing second |
|
| threshold has been exceeded |
|
|
|
adATLAS800CurrentUAS | MAJOR | the current interval unavailable |
|
|
|
adATLAS800CurrentCSS | WARNING | the current interval path code violation has been |
|
| exceeded |
|
|
|
adATLAS800CurrentLES | WARNING | the current interval line errored second threshold has |
|
| been exceeded |
|
|
|
adATLAS800CurrentCV | WARNING | the current interval line code violation threshold has |
|
| been exceeded |
|
|
|
When one of the Current Alert thresholds is exceeded, the corresponding event bit is set to 1 in the adDS1CurrentAlert variable in the DS1 Alert Table. When enabled, the ATLAS will send Alert Traps to each member of the Trap Destination List upon detecting status bit changes in adDS1CurrentAlert. If you have previ- ously set the corresponding enable bit = 1 in the adDS1CurrentArm variable and adDS1AlertEnable = On, then the ATLAS will send an Alert Trap message. A sin- gle Alert Trap message may report multiple event changes. The ATLAS clears the event bits after sending the Trap message or sending the response to a Get request for the adDS1CurrentAlert variable. The ATLAS clears the Current Alert values at the beginning of a new
| ATLAS 800 PLUS User Manual |
