1
configure 1-93
Telnet Commands
Do Not Allow AL_PA 0x00?
This option disallows ALPA values from being 0.
Initialize All Looplets?
When this is set, all looplets including the ones not in the same zone
are always re-initialized. This is required for certain RAID
subsystems to work properly during failover.
System Services The System Services fields are shown in Table1-6:
Descriptions of the system service setting fields are as follows:
rstatd
Dynamically enables or disables a server that returns information
about system operation information through remote procedure calls
(RPCs). The protocol provides for a wide-range of system statistics;
however, only Ethernet interface statistics (see ifShow) and system
up time (see uptime) are supported.
The retrieval of this information is supported by a number of
operating systems that support RPC. Most UNIX-based systems
(HP-UX, Irix, Linux, Solaris, etc.) use the rup and rsysinfo
commands to retrieve the information. See your local system
documentation for the appropriate usage of the these or equivalent
commands.
Table 1- 6 Configure Command System Services Parameters
Field Default Range
rstatd Off On/Off
rusersd Off On/Off
rapid On On/Off
thad On On/Off
Disable RLS probing On On/Off