1
1-222 EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
◆cp0 = hostname cp0, ip 10.77.77.75, subnet 255.0.0.0, gateway
0.0.0.0
◆cp1 = hostname cp1, ip 10.77.77.74, subnet 255.0.0.0, gateway
0.0.0.0
After each prompt the current value is shown. You may:
◆Press RETURN to retain the current value.
◆Enter an IP address in conventional dot (’.’) notation.
◆Enter NONE.
◆Press CTRL-C to cancel changes.
◆Press CTRL-D to accept changes and end input.
The final prompt allows you to set the new IP addresses immediately;
enter y to set new addresses immediately, enter n to delay the
changes until the next switch reboot. (Entering y closes the Telnet
session.)
A change to these values issues a Domain Address format RSCN (see
FC-FLA for a description of RSCNs).
Operands This command has the following operand:
option Specify which option you would like to
configure. This operand is only available in
v4.0. Valid options are as follows:
◆Option 0 sets the Ethernet IP Address,
Ethernet Subnetmask, Fibre Channel IP
address and Fibre Channel Subnetmask
of logical switch 0.
◆Option 1 sets the Ethernet IP Address,
Ethernet Subnetmask, Fibre Channel IP
address and Fibre Channel Subnetmask
of logical switch 1.
◆Option 2 sets the Ethernet IP Address,
Ethernet Subnetmask, gateway IP
address and Hostname of CP0.
◆Option 3 sets the Ethernet IP Address,
Ethernet Subnetmask, gateway IP
address and Hostname of CP1.
If no operand is specified the command
becomes interactive.