EMC DS-32B2, ED-12000B - page 434

1
1-418 EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
spdmode Specify the speed mode for the test. This parameter is only used
for v3.0 and v4.0 series based switches where it controls the speed
at which each port is operated. For 1G only products it is ignored.
The exact operation of modes 3 through 6 depends upon th e
loopback mode selected. When speed modes 3 through 6 are used
with cables, they must be connected EVEN to ODD or the test will
fail.
◆0: set all ports’ speed for auto-negotiate.
◆1: set all ports’ speed to lock at 1 GBit.
◆2: set all port’s speed to lock at 2 GBit.
For lbMode == 0,1 the following speed modes are available to test
the speed negotiation:
◆3: set all even ports’ speed for auto-negotiate, set all odd
ports’ speed for 1 Gb/s.
◆4: set all even ports’ speed for auto-negotiate, set all odd
ports’ speed for 2 Gb/s.
◆5: set all odd ports’ speed for auto-negotiate, set all even
ports’ speed for 1 Gb/s.
◆6: set all odd ports’ speed for auto-negotiate, set all even
ports’ speed for 2 Gb/s.
For lbMode== 2,3 the following speed modes are available to test
fifo underrun.
◆3,5: set all even ports’ speed for 2 G/s, set all odd ports’ speed
for 1 Gb/s.
◆4,6: set all even ports’ speed for 1 Gb/s, set all odd ports’
speed for 2 Gb/s.
gbicmode Specify the GBIC mode for the test. The GBICmode parameter
may be used to override the global GBIC mode described above
for the duration of this test. When it is enabled (1) testing is
limited to user ports with GBICs or SFPs installed.
-ports list Specify a list of user ports to test. By default all of the user ports in
the current switch are tested. This option may be used to restrict
testing to the specified ports.