1
reboot 1-387
Telnet Commands
reboot
Reboot the switch.
Syntax reboot
Availability Admin
Description The reboot command will reboot both logical switches and both CPs.Use
this command to reboot both logical switches and both CPs. The
reboot takes effect immediately as the switch resets, and then
executes the normal power-on booting sequence.
While the switch is rebooting, the telnet session is closed and all Fibre
Channel ports are inactive. If the switch was part of a fabric, the
remaining switches reconfigure.
A confirmation message is displayed to verify that you want to reboot the
switch.
Operands None
Example This example is for the DS-32B2:
switch:admin> reboot
Broadcast message from root (pts/1) Mon Aug 12 16:53:14 2002...
The system is going down for reboot NOW!!
switch:admin
Example This example is for the ED-12000B:
switch:admin> reboot
Warning: This command is being run on a control processor (CP)
based system and will cause the active CP to reboot. This will
cause disruption to devices attached to both switch 0 and switch 1.
To just reboot a logical switch on this system, use command
switchreboot(1M) on the logical switch you intend to reboot.
Are you sure you want to reboot the active CP [y/n]? y
See Also fastboot