
Table 2-12 Fax Setup menu (continued)
Menu item | Values | Description | ||
|
|
|
|
|
Fax Send Settings | Fax Dial Volume | Off |
Medium (default)
High
Use this feature to set the volume of the tones that you hear while the device dials the fax number.
Error Correction | Enabled (default) | When Error Correction Mode is enabled and |
Mode | Disabled | an error occurs during fax transmission, the |
| device sends or receives the error portion | |
|
| again. |
|
|
|
JBIG Compression | Disabled | The JBIG Compression reduces fax- |
| Enabled (default) | transmission time, which can result in lower |
| phone charges. However, using JBIG | |
|
| Compression sometimes causes |
|
| compatibility problems with older fax |
|
| machines. If this occurs, turn off the JBIG |
|
| Compression. |
|
|
|
Maximum Baud Rate | Select a value from | Use this feature to set the maximum baud |
| the list. | rate for receiving faxes. This can be used as |
|
| a diagnostic tool for troubleshooting fax |
|
| problems. |
TCF T.30 Delay | Default (default) |
Timer | Custom |
|
This setting should be left at the default value and only changed when directed by an HP technical support agent. Adjustment procedures associated with this setting are beyond the scope of this guide.
TCF Extend | Default (default) |
| Custom |
This setting should be left at the default value and only changed when directed by an HP technical support agent. Adjustment procedures associated with this setting are beyond the scope of this guide.
| Dialing Mode | Tone (default) | Select whether the device should use tone or |
|
| Pulse | pulse dialing. |
|
|
| |
|
|
|
|
| Redial On Busy | The range is between | Type the number of times the device should |
|
| 0 and 9. The factory | attempt to redial if the line is busy. |
|
| default is 3 times. |
|
|
|
|
|
| Redial On No Answer | Never (default) | Use this feature to specify the number of |
|
| Once | times the device should attempt to dial if the |
|
| recipient fax number does not answer. | |
|
| Twice | NOTE: Twice is available in locations other |
|
|
| than the United States and Canada. |
|
|
|
|
| Redial Interval | The range is between | Use this feature to specify the number of |
|
| 1 and 5 minutes. The | minutes between dialing attempts if the |
|
| factory default is 5 | recipient number is busy or not answering. |
|
| minutes. |
|
|
|
|
|
| Detect Dial Tone | Enabled | Use this feature to specify whether the device |
|
| Disabled (default) | should check for a dial tone before sending a |
|
| fax. | |
|
|
|
|
ENWW | Use the Administration menu 37 |